5 Different Kill Switches to Install in Your Car to Prevent Car Theft
With the rise of car theory, it is important to allow all steps to prevent the vehicle from being stolen. A precaution is to install a kill switch on your vehicle. These simple devices will keep your car from getting caught under them. But what kind of killwitch should be installed to prevent theft of your car?
In this guide, we cover five different kill switches for your car, allowing you to determine which one is best for you. We will also consider the total cost you can expect.
What is Automobil -Kill -Switch? If you don’t know what your car’s kill switch is, it can be difficult to choose from these five types. You must activate the kill switch to start the car. If not activated, certain circuits will not complete. There are several ways to operate the technology, but they contain all the switches. The reason for hiding the kill switch is that no one else knows where it is. If you know that there is a kill switch, you won’t have any issues starting the vehicle. Different types of kill switches include different installation and operational levels.
5 types of kill switches
A relay switch in the fuel system can be installed to prevent fuel from reaching the engine. There is also an easy-to-use battery separator. Otherwise, you can choose the remote car battery switch, ignition wire kill, or fuse box switch.
Here is a more detailed list of the types of kill switches that you can attach to your car.
1. Fuel system relay switch
It cannot pass through the line to the engine until the fuel pump relay switch is activated. Without fuel, the engine cannot start. Interestingly, the engine continues to increase, but there is no gas to turn it. Therefore, when a thief climbs into your car, he will believe something is wrong with your car and believe it will continue.
To install a relay switch for a fuel system, you must first localize the vehicle’s wire harness. You need to spline the fuel switch and choose a comfortable location for the kill switch. Run the cable and connect the fuel switch relay to the kill switch and you’re ready.
2. Battery separator
With the battery split switch, you need to remove the negative plug and put the switch in between. The negative lead will be the kill switch currently installed in the battery post terminal. If activated, the car will not generate performance from the battery. However, if the switch is rotating, the vehicle can start normally. If you run the cables to assemble the car’s switch, you don’t need to go under the hood each time you start the engine. However, since the battery contains this memory, the radio set and clock settings will be reset every time you use it.
3. Remote car battery switch
Another type of battery mounted is this remote control option. Hold the remote control on the key for easy access. The great thing about this option is that it can activate you whenever you are nervous, even if you are not in the car.
This switch is mounted on the battery like a wired version. By using magnets, the switch can use the battery when driving and turning off when protecting the car. However, I run into the same memory issue with the last battery option.
4. Village Wire Switch
Without an ignition system that runs through the well, there is no way to start a car. This switch interrupts ignition flow by adding a break to the cable. To install, you must disconnect the ignition cable and place the connection on each side of the switch. You can transfer the switch yourself at a secret location in the vehicle’s cabin.
However, installing this device is a little more complicated. If you are unfamiliar with the ignition system, please refer to the diagram in the service manual. You may need to cut the appropriate wire and also prefer to solder the connection for a better fit.
5. Fuck Runbox Kill Switch
During this kill switch, the power supply prevents the power from reaching the car, but he does not disconnect it with the battery. Instead, the power supply is removed directly into the fuse box. Of course, you can pull out ignition protection when you leave the vehicle and use it again when you are ready to drive. However, this process can be a nuisance, especially if the safety box is in a challenging location.
It is much easier to install a switch that kills a particular fuse of your choice. They run a switch to the corresponding fuse and place it in an inconspicuous place.
