Symptoms of Coolant Temperature Sensor Failure
The CTS uses a resistor to measure the temperature, which is then used as a thermostat. As the temperature increases, the sensor resistance changes in proportion to the temperature, and the current increases.
The ECU sends electrical signals through the CTS, measuring voltage drops and converting current information into temperature readings.
The ECU uses this information to control fuel injection, ignition timing, and the electric radiator fan to maintain optimal temperatures. As the engine cools, the ECU supplies an air/fuel mixture, or a higher proportion of fuel compared to the amount of air entering the engine. If the engine starts to overheat, the ECU activates the radiator fan. For example, this is a common behavior when standing at a traffic light for a long time on a hot day. Some cars shut off their engines when they get too hot to prevent engine damage.
Symptoms of Coolant Temperature Sensor Failure
Every part wears out, and this bag is no different. Troubleshooting the cooling system is important because it can cause the engine to overheat and be expensive and time-consuming to fix. 1) Engine heat
An overheated engine will show several warnings, such as a high temperature reading on the dashboard gauge and sometimes a white “steam” under the hood (indicating that it is boiling cooling, which means leaving the system – this is a bad sign!
Low cooling is a problem. A cooling trap can cause the engine to overheat if the reserve is not sufficient to properly cool the engine.
2) Poor engineering
If the sensor fails, it can send incorrect temperature data to the ECU, causing engine malfunctions such as reduced power or slow response.
If the vehicle struggles on hills, idles fast, and is hard to start, especially after warming up, we recommend having the CTS checked. 3) Increase fuel consumption
A faulty sensor can cause a significant reduction in fuel efficiency as the computer instructs how much fuel to inject into the engine’s cylinders.
4) Black smoke comes out of the exhaust
Also, a fuel mixture that is too rich can cause black smoke to appear in the exhaust which can attract the attention of other drivers.
5) DEQ emissions test failed
If excessive fuel or by-products occur due to improper combustion, this is indicated as a problem that must be corrected during testing. Although other sensors and pens should also be checked, the CTS may be the cause of the problem.
6) The thermometer was incorrect
If the temperature reading on the dashboard gauge does not show correctly, such as reading “cold” when the engine is fully warmed up, the coolant temperature sensor is giving incorrect information. 7) The AC box stops working
If overheating occurs, many vehicles will activate a “safe” mode that can shut down the engine, keep the engine cooling fan running, and turn off the interior air conditioning for better comfort. eliminate engine heat.
8) Check if the check engine light is on
A “check engine” light on the dashboard indicates that the ECU has detected a problem and is treating the appropriate code. If this light comes on and is accompanied by the above symptoms, we recommend checking the CTS.
